Configuring Just-In-Time Production Parameters

Use the Transaction Set Maintenance form to configure parameters for the Just-In-Time Production transaction.

  1. Open the Transaction Set Maintenance form.
  2. Select SF_JITProd from the grid.
  3. Specify this information:
    Fill Warehouse
    Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.
    Successful Message
    Select this check box to show a success message when the transaction is successfully completed.
  4. On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:
    Allow Cross-Docking
    Select this check box to allow cross docking from this transaction.
    Default Container
    To use a container by default, specify Y.
    Receiving Location
    Specify a default receiving location where the material is received.
    Putaway
    Select this check box to allow users to perform put away transactions from within this transaction.
    Discrete Transcation
    Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.
  5. Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
  6. Click Save.
Related topics