Configuring Work Center Parameters

Use the Transaction Set Maintenance form to configure parameters for the Work Center form.

1. Open the Transaction Set Maintenance form.
2. Select SF_WorkCenterUI from the grid.
3. Specify this information:

   Fill Warehouse

   Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

   Successful Message

   Select this check box to show a success message when the transaction is successfully completed.

4. On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

   Work Center Popup Enabled

   Select this check box to open a separate form when users perform an action, such as Add Run or Start Indirect, allowing users to complete the action on the newly opened form. For example, if a user selects an operation and taps Add Run, the Workset Maintenance form is opened, allowing the user to add the operation to the workset using that form. Clear this check box to complete most actions listed in the Tasks section or Workset section directly from the Work Center form when users perform an action. For example, if a user select an operation and taps Add Run, the operation is immediately added to the workset without opening any additional forms.

   Discrete Transaction

   Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.

   Show Service Labor Tab

   Select this check box to display the Service Labor tab, allowing employees to report time to SRO jobs.

   Show Project Labor Tab

   Select this check box to display the Project Labor tab, allowing employees to report time to projects.

5. Click Save.