Configuring Labor Reporting Parameters

Use the Transaction Set Maintenance form to configure parameters for the Labor Reporting mobile scanner transaction.

Open the Transaction Set Maintenance form.
Select SF Labor Reporting Settings from the grid.
Specify this information:

Fill Warehouse

Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

Successful Message

Select this check box to show a success message when the transaction is successfully completed.
On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

Allow Job Close With Open Reqs

Select this check box to prevent users from closing a job if all material has not been issued.

Check Qty Received

Select this check box to warn users if they are attempting to report a quantity of good and scrapped items that exceeds the quantity received.

End Run Only

Select this check box to enable the End Run Only transaction.

Discrete Transaction

Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.
Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
Click Save.