Configuring Start Service Labor, End Service Labor, and SRO Material Parameters

Use the Transaction Set Maintenance form to configure parameters for the Start Service Labor, End Service Labor, and SRO Material transactions.

Open the Transaction Set Maintenance form.
Select SF_ServiceLabor from the grid.
Specify this information:

Fill Warehouse

Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

Successful Message

Select this check box to show a success message when the transaction is successfully completed.
On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

HR Updateable

Select this check box to display default values in the Work Hr and Bill Hr fields.

Allow Bill Code Entry

Select this check box to allow users to specify a bill code.

Discrete Transaction

Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.
Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
Click Save.