Configuring End Team Run, Start Team Run, Team Maintenance, and Team Member Reporting Parameters

Use the Transaction Set Maintenance form to configure parameters for the End Team Run, Start Team Run, Team Maintenance, and Team Member Reporting transactions.

Open the Transaction Set Maintenance form.
Select SF_TeamsTransaction from the grid.

Note: There are additional parameters you can configure for the End Team Run and Team Member Reporting transactions by selecting MES_JobMove from the grid. For instructions on setting these additional parameters, see Configuring End Run, End Run Only, End Machine, End Team Run, Job Move, and Team Member Reporting Parameters.
Specify this information:

Fill Warehouse

Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

Successful Message

Select this check box to show a success message when the transaction is successfully completed.
On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

Allow Team Member to Report Quantities

Select this check box to allow users to report quantities. Clear this check box to allow only administrators or supervisors to report quantities.

Allow User to be Removed from Team

Select this check box to allow users to remove themselves from a team. Clear this check box to allow only administrators or supervisors to remove members from teams.

Discrete Transaction

Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.
Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
Click Save.