Configuring Workset Maintenance Parameters

Use the Transaction Set Maintenance form to configure parameters for the Workset Maintenance form.

1. Open the Transaction Set Maintenance form.
2. Select SF_WorksetMaint from the grid.
3. Specify this information:

   Fill Warehouse

   Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

   Successful Message

   Select this check box to show a success message when the transaction is successfully completed.

4. On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

   Report Quantity

   Select this check box to allow users to report quantities.

   Discrete Transaction

   Select this check box to require generic users to sign in again using the Employee Authentication form after performing this transaction. Clear this check box to allow users to perform additional transactions, after performing this transaction, without signing in again.

5. Click Save.