Configuring Cycle Count Parameters

Use the Transaction Set Maintenance form to configure parameters for the Cycle Count mobile scanner transaction.

Open the Transaction Set Maintenance form.
Select CycleCount from the grid.
Specify this information:

Fill Warehouse

Select this check box to pre-fill the warehouse on the transaction with the warehouse assigned to the user. The user can change this warehouse for a specific transaction if needed.

Successful Message

Select this check box to show a success message when the transaction is successfully completed.
On the Transaction Parameters tab, in the Parameter and Value columns, configure these parameters:

Input Item

Select this check box to require users to confirm the item number by scanning it.

Input Lot

Select this check box to require users to confirm the lot number by scanning it.
Optionally, on the Transaction Parameterstab, select Label Print Parameters to configure label printing parameters for this transaction.
Click Save.