Configuring Loading Transaction Parameters

Use the Transaction Set Maintenance form to configure parameters for the Loading transaction.

  1. Open the Transaction Set Maintenance form. If you are configuring parameters that only apply for a specific warehouse, that warehouse is displayed in theWarehouse field. If you are configuring general parameters, which apply by default throughout the application, the Warehouse field is blank and unavailable.
  2. In the Transaction Name column, select Loading.
  3. Specify this information:
    Fill Warehouse
    This parameter has no effect for this transaction.
    Successful Message
    Select this check box to show a success message when the transaction is successfully completed.
    Default Order Type
    Select a default order type for this transaction. The user can change this value.
  4. On the Transaction Parameters tab, specify this information for each order type:
    Ignore Sealing Check
    Select this box, to load a container irrespective of the not sealed status.
    Ignore Dock Check
    Select this box, if the dock number need not to be entered manually at time of loading.
    Default Dock
    Specify a default dock, if the dock is not required to be entered at time of loading.
    Note: This parameter is only enabled, if the Ignore Dock Check parameter is selected.
  5. On the Order Types tab, specify this information for each order type:
    Enabled
    Select this check box to allow this order type to be used in this transaction.
    Specific Parameters
    Select this check box to use order-specific parameter settings for this order type. Clear this check box to use the default parameter settings for this order type.
  6. Click Save .
Parent topic: Overviews and Procedures
Parent topic: Transaction Set Maintenance