Running the Indented Unit Configuration Report

Use the Indented Unit Configuration Report utility to generate a report output showing unit configuration and warranty information for the subcomponents of the unit. The report is time phased so the change in configuration over time can be displayed. Follow these steps to run the report:

Open the Indented Unit Configuration Report.
Specify this information:

As Of Config Date

Indicate the last possible configuration date of a unit in order to qualify for this report. Any unit with a configuration date earlier than this value is included in the report. This field defaults to the current date.

Levels to Display

Select the lowest level to be displayed in the indentation of the unit configuration. If the value is set to 0 then all levels are displayed.

Include Warranty

Select this check box to include the warranty information associated with the unit as part of the report output.

Include Component Serial Numbers

Select this check box to include the component serial numbers in the report output.

Page Break Between Units

Select this check box to include page breaks between units on the report.

Show Future Additions

Select this check box to show components that are added to the unit at a later date in the report output.

Show Removed

Select this check box to show components that have been removed from a unit in the report output.

Highlight Expired

Select this check box to highlight expired components in green on the report output.
For these fields, select the range of values to include:
- Unit
- Item
- Customer
Click Preview to view an output of the report.
Click Print to run the utility and print the report.