Adding a gauge to a form

With the form open, go into Design Mode.
From the toolbox, select “Gauge” , and draw the component where you want it on the form.
From the “Component” property sheet, select “Data Source > Binding” and then click the ellipses (“...”) button on the right.
In the “Edit Component Data Binding” dialog box, “Type” drop-down list, select “Gauge”.
Click “Edit”.
In the “Specify Gauge Settings” dialog box, on the “General” tab, specify at least the “Gauge Type”.
Specify the gauge settings on the “General” tab, as desired.

See “Specifying general settings for gauges”.

You must specify at least this information:
- “Gauge Type” - Select the type of gauge you want to display.
  To preview the gauge types, see “Gauge samples”.
- “Gauge Data”
  注意：In some earlier versions of Mongoose, the “Gauge Data” group is labeled as “Chart Data”.
  - To base the gauge display on data in an IDO collection, select the “Collection” option.
  - To base the gauge display on data from a Critical Number, select the “Critical Number” option.
Optionally, use the other tabs on the “Specify Gauge Settings” dialog box to set up additional options for the gauge.
To apply your changes and save the gauge, click “OK” .