Use the
Indented Unit Configuration Report utility to
generate a report output showing unit configuration and warranty information
for the subcomponents of the unit. The report is time phased so the change in
configuration over time can be displayed. Follow these steps to run the report:
-
Open the
Indented Unit Configuration Report.
-
Specify this information:
- Include Warranty
- Select this check box to include the warranty information
associated with the unit as part of the report output.
- Level
- Select the lowest level to be displayed in the indentation of
the unit configuration. If the value is set to 0 then all levels are displayed.
- Page Break Between Units
- Select this check box to include page breaks between units on
the report.
- Starting/Ending Unit
- Select the range of units to include for the report.
- Starting/Ending Item
- Select the range of items to include in the report.
- As Of Config Date
- Indicate the last possible configuration date of a unit in
order to qualify for this report. Any unit with a configuration date earlier
than this value is included in the report. This field defaults to the current
date.
-
Click
Preview to view an output
of the report.
-
Click
Print to run the utility
and print the report.