System settings

These three options can be set for RF load processing. To display these options, select Administration > System Settings.

  • AllowRFLoadOverride: (Default = on).

    When this option is selected, you can override the suggested license plate load task during RF loading and pick another license plate to load when that license plate is on the same route and stop. If this option is turned off, you can only complete the load task for the ID that the system suggests. Completing the task for the ID that the system suggests can be difficult if multiple pallets or cases are staged and you must find the task the system suggests.

  • CompleteLoadTaskOnTripToDock: (Default = off).

    When this option is on, you can complete a load task for the current license plate if the correct Door location is confirmed on the trip to dock move performed as part of the pick process (Live Loading). If this option is turned off, you must confirm the trip to dock move to an outbound staging location, not directly to the door. To use live loading capabilities the order must be assigned to an open load that has been correctly configured.

  • StatusLoadID: (Default = on).

    When this option is selected, during RF loading, the load automatically updates to a Loaded status when the last task is complete. If it is not selected, the following message is sent to the RF loader: 

    Do you want to set this load to ‘Load’ status?

Lane table

To display the lane table, select Crossdock > Management > Lane. This table establishes outbound lanes for RF load tasks. To apply outbound lanes to a load using the Load Planning page, this table must be configured.

Note: If you do not purchase Crossdock, this is not available.

Door

Door assignment plays an essential role in RF load processing. All orders must be assigned to a door for the load task to be dispatched to you. A door is basically considered a location and can be defined on the location table.

To display the location table, select Configuration > Location. Each door used for RF Loading must be set up in the Location table to have a STAGED location type.