Performing cycle count by scanning each piece, location, and item

Note: 
  • The EPScan Item, Loc option supports only the master unit UOM of the pack.
  • You cannot perform Cycle count for an item if configured for Serials Capture, Catch Weights, or Summary Weights.
  • The CC discrepancy rule is not considered when using the existing Each Piece Scan option.
  1. Select Cycle > EPScan Item, Loc. The EPCCSL1 screen is displayed.
  2. Scan or specify a valid location and press Enter.
  3. Scan or specify the Item and press Enter.
    Note: This information is displayed for the selected item after successful validation:
    • Item
    • Location
    • Description
    • Owner
    • Pack
    • UoM
    • Scanned quantity
    • Quantity
  4. Press Enter until you complete the count.
  5. To add inventory, you are redirected to the Blind No ASN option when the scanned item is not available in the system.
  6. Specify this information on the Blind Rcpt screen:
    • The owner and item and press Enter.
    • The quantity and location and press Enter. You are redirected to the CC EPCCSL1 screen to continue the scanning process.
    • Press the ESC key for redirecting to the EPCCSL1 screen.
  7. Press F4 (EPCCSL4) or F5 (EPCCSL2) to complete the scanning process.
  8. Press F8 to clear all scanned quantities of the location and start scanning from the beginning.