Post-pick validation

If validation has been enabled, the application works through the steps below to identify and process the appropriate validations. All of these steps are complete before the application finalizes the RF pick confirmation.

• First, the application searches for any routines to be run in which the Customer, Owner, and Item fields are all populated (not blank). If the routine is defined and is enabled, the application runs the validation and completes the process.
• If the above conditions were not met, the application searches for any routines to be run in which the Customer, Owner, and Item fields are all blank. If the routine is defined and is enabled, the application runs the validation and completes the process.
• In each of the above steps, it is possible to find more than one Post-pick Validation process. The application executes the validations based on the sequence number until they have all been processed or an error is encountered.
• If the above searches are unsuccessful, there are no post-pick validations to be done.
• If the validation routine fails, a Validation Failed message displays on either the workstation or RF device you are using. The pick is not confirmed.
• The application ships with six default post-pick validation detail routines:
  • Shelf Life Comparison
  • Check Lot
  • Check Location
  • Check Item
  • Check ID
  • Check New LOT, LOC, ID