Moving held inventory

To prevent inventory that is on hold from being moved accidently, the application can be configured to check current inventory hold information prior to allowing inventory to be moved by an RF operator. These system settings used to control this are:
WARNMOVEHELDLPN
When this flag is ON, a message will be displayed to the RF operator when they initiate the move of a license plate that is on hold. If the flag is OFF, the move will be allowed without notifying the operator that the License Plate is on hold.
Note: This check is performed when the user presses Enter on the first RF move screen.
WARNMOVEFROMHELDLOC
When this flag is ON, a message will be displayed to the RF operator when they initiate the move of inventory that is currently in a Location that is on hold. If the flag is OFF, the move will be allowed without notifying the operator that the from location is on hold.
Note: This check is performed when the user presses Enter on the first RF move screen
WARNMOVETOHELDLOC
When this flag is ON, a message will be displayed to the RF operator when they attempt to move inventory to a Location that is on hold. If the flag is OFF, the move will be allowed without notifying the operator that there is an active hold on the new location.
Note: This check is performed when the user presses Enter on the first RF move screen

To configure the above settings, select Administrator > System Settings. All of these settings are ON by default