Clocks 7.1.0.4 resolved issues
Total: 3 issues
----------------
WFMC-4547
Swipe confirmation message is not shown under Supervisor Mode
When schedule validation is enabled on a WB8000 or WB9000 clock, the swipe confirmation message is not shown for a labor metric change (time code, department, job, project, or docket) for an employee in Associate mode. In addition, the swipe confirmation message is not shown in Supervisor mode.
Outcome
Fixed by WFMC-4581.
----------------
WFMC-4581
Enhancements to selection of messages displayed at the end of swipes
Added the following swipe type specific messages to settings.conf. In the absence of a swipe type specific message configuration, the message configured for message.validation.swipe will be used:
message.validation.swipe = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.on = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.off = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.timecode = ^&F^&N^&S ^&D at ^&h:^&m ^&A
message.validation.swipe.department = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.directionless = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.docket = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.job = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.project = ^&F^&N^&S at ^&h:^&m ^&A
message.validation.swipe.newemployee = ^&F^&N^&S at ^&h:^&m ^&A
----------------
WFMC-4592
Enhanced Schedule Validation is applied for IN/OUT swipes with time codes excluded via skipwhenTimeCodes setting
IN and OUT swipes with time codes specified in the skipwhenTimeCodes setting are failing schedule validation.
Outcome
Fixed by using raw swipe to get time code.
----------------