Using Supervisor Mode

To perform any supervisor task, you must be in supervisor mode.

To enter supervisor mode:

  1. Select F4 (More) > F4 (Super.).
  2. Specify your supervisor badge number and press ENT.
    Note: You may not have to enter a badge number if your administrator has enabled Identification mode for biometric validation. If this is the case, only a fingerprint is required for authentication. For more information, contact your system administrator.
  3. If prompted for verification, choose an option:
    • Specify your PIN and press ENT on the clock keypad.
    • Place your finger on the fingerprint reader.

    The label Supervisor Mode is displayed.

You are now in supervisor mode. The options that are available depend on the configuration of your clock.