Punching in

  1. Optionally, press Swipe Emp ID (F4) to punch in using your employee ID.
  2. Press Clock In (F1) on the clock screen.
  3. Enter your badge number or employee ID using one of these options:
    • Type in your badge number using the numeric keypad on the clock.
      Note: If your badge number is alphanumeric (combination of letters and numbers), you cannot enter the badge number on the clock. You will have enter your badge number by swiping your card.
    • Place your proximity badge on the proximity sensor of the clock.
    • Swipe your magnetic or barcode badge through the card insert on the right side of the clock.
    • If you started by pressing Swipe Emp ID (F4), type in your employee ID number using the numeric keypad on the clock.
    Note: You may not have to enter a badge number if your administrator has enabled identification mode for biometric validation. If this is the case, only a fingerprint is required for authentication.
  4. Provide PIN or biometric authentication, if prompted.
  5. Select additional labor metrics as required.
    The options depend on the clock configuration. For example, you might be prompted to select a department and then a job when clocking in.
  6. Press Submit.
    If your Clock In is successful, a confirmation message is displayed. Otherwise an error message is displayed.