Punching in other changes

Use change punches to process labor metric changes such as a job or department switch. For example, if you work as a cashier and as a customer service representative, a Job change punch records when you switch from one job to the other.

You to change these labor metrics depending on the configuration of the clock:

Department
Docket
Job
Project
Time Code

Enter your badge number, or press Swipe Emp ID and enter your employee ID.

Note: If identification mode for biometric validation is enabled, then only a fingerprint or facial recognition is required for authentication.
Provide PIN or biometric authentication, if prompted.
The system displays a list of possible values for the change selected in the previous step.
Press the function key corresponding to the change required.
For example, the baseline configuration of the clock uses F3 (Dept.) and F4 (Job).
From the list, select a value by either using the Up or Down keys on the keypad, or by selecting the number on the keypad that corresponds to the desired valued.
For example, 3 for the third value in the list. You can also use the function keys F1 (Prev) and F2 (Next).
Note: The top right of the list header indicates the current page number and the total number of pages in the list.
Press ENT to confirm the selection.
If the change punch is successful, a confirmation message is displayed. If it is unsuccessful, an error message is displayed. The error message that is displayed depends on the validation rules defined in the clock configuration.