Punching in
- Optionally, press Swipe Emp ID to punch in using your employee ID.
- Press IN.
-
Enter your badge number or employee ID using one of these
options:
- Type in your badge number using the numeric keypad on the
clock. Note: If your badge number is alphanumeric (combination of letters and numbers), you cannot enter the badge number on the clock. You must enter your badge number by swiping your card.
- Place your proximity badge on the badge picture located under the IN and OUT keys.
- Swipe your magnetic or barcode badge through the card insert on the right side of the clock.
- If you started by pressing Swipe Emp ID, type in your employee ID number using the numeric keypad on the clock.
Note: You may not have to enter a badge number if your administrator has enabled Identification mode for biometric validation. If this is the case, only a fingerprint or facial recognition is required for authentication. - Type in your badge number using the numeric keypad on the
clock.
- Provide PIN or biometric authentication, if prompted.
-
Select additional labor metrics as required.
The options depend on the clock configuration. For example, you might be prompted to select a department and then a job when clocking in.
-
Press Submit.
If your clock in is successful, a confirmation message is displayed. Otherwise an error message is displayed. Error messages vary depending on the type of error and the configuration of the clock.