Starting Breaks

  1. Press the Start Break button.
  2. Specify your ID or swipe your badge.
  3. If your WB2000 Series Clock has been set up for fingerprint verification, place your finger on the scanner when prompted.

If your punch is successful, the WB2000 beeps once, the VALID light flashes green, and the “TCODE WRK OK” message is displayed. You are now punched out for your break.

If your punch was unsuccessful, the WB2000 beeps three times, the INVALID light flashes red, and the Invalid Badge message is displayed. This message means that the clock reader does not recognize your ID or badge.

Try punching in again using these tips:

  • Ensure you are typing your ID correctly.
  • Ensure you are swiping your badge properly.

If you receive the same error message, contact your supervisor.