Configuring the Consecutive Types validation

With the Consecutive Types validation you can prevent similar swipes within a certain period and based on one or more conditions.

  1. In WFM, select Maintenance > Reader Setup > Clock Validations.
  2. Click Edit for the CONSECUTIVE_TYPES validation
  3. Under Reader Types, specify the TimeTrack reader and click Save.
  4. Select Maintenance > Reader Setup > Reader Configurations > Reader Configuration Setup.
  5. Click Edit for your current reader configuration.
  6. In the Configuration Properties search box, specify validation.consecutive_types and click Find.
  7. Specify the appropriate values for these properties depending on your business requirements. A description of each property is also available in the Property Description column:
    validation.consecutive_types.enable
    You must enable this property for the validation to work.
    validation.consecutive_types.length_in_minutes

    The amount of time, in minutes, for which two swipes of the same type is not allowed one after the other (0 - to not allow swipes of the same type at all).

    For example, you could set this value to 5 minutes for the minimum length. With this configuration, if you clock in you cannot clock in again within 5 minutes. The clock in punch is rejected.

    validation.consecutive_types.skip_in_supervisor_mode
    Skip this validation in supervisor mode.
    validation.consecutive_types.type
    Defines which swipe types trigger the validation. Specify a comma separated list for multiple swipe types.

    Default values for the above properties can be found at Maintenance > Reader Setup > Reader Configurations > Configuration Property Definitions.

  8. Click Save.