Function key label configuration

A label is displayed above each function key. The label describes the action associated with that function key. Labels can be six to ten characters long and use one or two lines. Use \n for line breaks.

The number of characters that you can use on the label varies depending upon the size of the characters that you use. For example, an upper case M takes more space on the display than a lower case i. If your label uses mostly large characters, then the space on the label limits you to fewer characters.

This table shows the labels for clock punches:

Key	Sample Value	Description
DEPARTMENT_CHANGE	Dept	Change departments
DOCKET_CHANGE	Docket	Change docket
JOB_CHANGE	Job	Change job
PROJECT_CHANGE	Project	Change project
TIMECODE_CHANGE	TCODE	Change time code
START_MEAL	Start Meal	Start meal break
END_MEAL	End Meal	End meal break

This table shows the labels for supervisor mode:

Key	Sample Value	Description
SUPERVISOR_MODE	SUPER	Enter Supervisor mode
BIO_ENROLL	ENROLL	Enroll biometric template for employee
BIO_UNENROLL	UnEnroll	Unenroll biometric template for employee
FACE	Face	Enroll employee's face for facial recognition.
FINGERPRINT	Finger	Enroll employee's fingerprint

The labels listed earlier in this chapter for clock punches are also available for supervisor mode. For example, the label for DEPARTMENT_CHANGE can be used to allow a supervisor to make a department change punch for an employee.

Press the MENU key and select F3 (Admin.) on the keypad to access System Configuration. This table shows the labels for the Credentials page:

Key	Sample Value	Description
LOGIN	Login	Log in to the System Menu
LOGIN_CANCEL	Cancel	Cancel log in to the System Menu

This table shows the labels for setting the clock IP Address through the System Configuration page:

Key	Sample Value	Description
DYNAMIC_IP_CHANGE	Enable	Confirm change to DHCP
STATIC_IP_CHANGE	Update	Confirm values for Static IP
IP_CANCEL	Cancel	Cancel IP change operation