Punching Out

To punch out:

  1. Press Punch Out. The clock reader’s light changes to orange and the following message is displayed: 

    End shift
Enter ID
  2. Specify your ID, swipe your badge, or scan your proximity badge.
  3. If your WB5500 Series Clock has been set up for fingerprint verification, place your finger on the scanner when prompted.

    If you punch out is successful, the WB5500 Series Clock beeps twice, the light beneath the keypad flashes green, and the message Shift ended followed by the current time is displayed. You are now punched out.

    If your punch out is unsuccessful, the WB5500 Series Clock beeps three times, the light beneath the keypad flashes red, and one of the following messages is displayed:

    • Invalid ID

      The clock reader does not recognize your ID or badge. Try punching out again using these tips:

      • Ensure that you are specifying your ID correctly.
      • Ensure that you are swiping your badge properly.

      If you receive the same error message, contact your supervisor.

    • Already off

    You are not punched in. Either you forgot to punch in when you started working or you have already been punched out, maybe by your supervisor.

    You are punched out but the clock reader has not recorded the current time as when you stopped working.

    Contact your supervisor.