Product Setup - Cut field descriptions

Fields are presented in alphabetical order within each section.

Cut Dimension Definition

Cut Type

Specify the cut type No Cut, Linear Cut, or Dimensional Cut. A linear cut has length. A dimensional cut has length and width.

Linear Cut

The fields in this section are available when the Cut Type is set to Linear Cut.

1st Part

Select Integer to require an integer. An integer field ignores any entered decimal places.

Select Decimal to allow a decimal value.

Specify the Unit. This dimension is a multiple of the cut product's stocking unit. The multiplier is based on the 1st Part unit value. If the unit value is the stocking unit then the multiplier is 1. If the unit value is an alternate unit setup in Product Extended Unit Conversion Setup or SA Table Code Value Setup-Unit Conversion, then the multiplier is taken from the alternate unit conversion factor.

2nd Part

Select Integer to require an integer. An integer field ignores any entered decimal places.

Select Decimal to allow a decimal value.

Specify the Unit. This dimension is a multiple of the cut product's stocking unit. The multiplier is based on the 2nd Part unit value. If the unit value is the stocking unit then the multiplier is 1. If the unit value is an alternate unit setup in Product Extended Unit Conversion Setup or SA Table Code Value Setup-Unit Conversion, then the multiplier is taken from the alternate unit conversion factor.

Increment

Specify the increment. This dimension is a subset of the 1st Part and 2nd Part Unit dimensions and defines the numerical relationship to each. For example, if the 1st Part Unit is set to "foot" and the 2nd Part Unit is set to "inches," the increment would be 12.

Length

Select 1 Part to define a single unit of measure.

Select 2 Part to define a two-part unit of measure.

Dimensional cut

The fields in this section are available when the Cut Type is set to Dimensional Cut.

1st Part

Select Integer to require an integer. An integer field ignores any entered decimal places.

Select Decimal to allow a decimal value.

Specify the Unit. This dimension is a multiple of the cut product's stocking unit. The multiplier is based on the 1st Part unit value. If the unit value is the stocking unit then the multiplier is 1. If the unit value is an alternate unit setup in Product Extended Unit Conversion Setup or SA Table Code Value Setup-Unit Conversion, then the multiplier is taken from the alternate unit conversion factor.

2nd Part

Select Integer to require an integer. An integer field ignores any entered decimal places.

Select Decimal to allow a decimal value.

Select Fraction to allow a fractional value.

Specify the Unit. This dimension is a multiple of the cut product's stocking unit. The multiplier is based on the 2nd Part unit value. If the unit value is the stocking unit then the multiplier is 1. If the unit value is an alternate unit setup in Product Extended Unit Conversion Setup or SA Table Code Value Setup-Unit Conversion, then the multiplier is taken from the alternate unit conversion factor.

Increment

Specify the increment. This dimension is a subset of the 1st Part and 2nd Part Unit dimensions and defines the numerical relationship to each. For example, if the 1st Part Unit is set to "foot" and the 2nd Part Unit is set to "inches," the increment would be 12.

Length

Select 1 Part to define a single unit of measure.

Select 2 Part to define a two-part unit of measure.

Width

Select 1 Part to define a single unit of measure.

Select 2 Part to define a two-part unit of measure.