CIP tab

This tab is displayed only if the type is set to CIP rule.

  1. Click the CIP tab.
  2. Select enable clean-in-place check box to enable the CIP solver.
    Note: 
    • If you select this option, the other options on this tab and the CIP objective section on the Objectives tab are enabled.
    • If this check box is cleared, CIP batches are considered as normal batches.
  3. Specify this information, if you have enabled the CIP solver:
    enable min limit
    Select this check box to enforce the minimum constraint CIP rule for the selected batches in the work area.
    Note: If the minimum value is not specified for the CIP rule, this option is disabled.
    enable min limit for not selected CIP
    Clear this check box if you have selected the enable min limit check box and require to extend this option for the non-selected batches in the work area. If non-selected batches in the work area are in conflict with the minimum constraint CIP rule, this option can be used to manage the conflicts.
    large changeover replaces CIP
    Clear this check box for not considering the changeover limit of CIP rule.
    Note: 
    • If this check box is cleared, a CIP batch replaces a large changeover that, based on the CIP rule, must replace a CIP batch.
    • If changeover limit is not specified for the CIP rule, this option is disabled.