Inspection Available report

The Inspection Available report shows inspections performed ad hoc against the filtered options. For each inspection listed, the report shows information about when it was last checked and whether there were violations on that inspection that remain unanswered. It also shows whether recorded measurements were OOS and triggered out-of-control alerts.

You can use the Inspection Available report in these ways:

Operators can see checks they must perform on the current production run
As a base report for the To Do menu to filter on assets, inventory, or production for required data collection.
As a saved report to show required inspections that must be performed on inventory
As a sub report to enable inspections to be performed against an inventory pack

Here are some examples of the data contained in the report:

Inspections performed against a specific machine
Inspections performed against a machine in a department, belonging to a line or in a machine group area
Inspections performed on the current or selected production order
Inspections performed against inventory produced on the current or specific job
Inspections performed against received inventory
Inspections performed against inventory in a particular location
Inspections performed against specific assets or assets of a particular type
Visual inspection checks
Recently performed or suspended checks for an inspection
Documents relating to an inspection
SPC chart sets and analysis
Alarms raised against an inspection