Adding a maintenance procedure step

  1. Select Configuration > Maintenance > Maintenance Procedures. The Maintenance Procedures screen is displayed.
  2. Select a record and click Steps. The Maintenance Procedure Steps screen is displayed at the bottom.
  3. Click Add. The Add window is displayed.
  4. Specify this information:
    Step Order
    The order in which the steps are displayed in the procedure.
    Step Type
    The type of the step. See, Maintenance steps.
    Instructions
    The instructions associated with the step to be displayed to the engineer.
    Description
    The description of the step.
    LSL
    The lower specification limit for the measurement. This setting is displayed when Step Type is set to Variable.
    Nominal
    The nominal value for the measurement. This setting is displayed when Step Type is set to Variable.
    USL
    The upper specification limit for the measurement. This setting is displayed when Step Type is set to Variable.
    Units
    The unit of measure for the specification limits and the measurement. This setting is displayed when Step Type is set to Variable.
  5. Click OK.