Define Work Center Scheduling Settings for Manufacturing Order

This document explains how you assign different values that affect the panels' appearance when you use work center scheduling.

Outcome

As an outcome to this process:

  • You have defined a start panel, date format, facility and view.
  • You have predefined some of the parameters that control which manufactured orders can be work center scheduled.

Your settings are saved and will be valid until you change them.

This procedure can be used in the practical management of work center scheduling, allowing a more standardized and easier scheduling. If the work temporarily or permanently changes, the work can be adjusted to the change.

Follow These Steps

  1. Start 'Work Center Schedule. Open' (PMS230).

  2. Select F13 "Settings" to start the P panel.

  3. Select start panel B.

  4. Select the date format.

  5. Select the facility.

  6. Select the view.

  7. Activate the 'Lock view' field if you do not want the view to be able to be changed.

  8. Activate the 'Create 1 page' field if you want the sub-file to be created one page at a time.

  9. Activate the 'Display maintenance order module' field if you want the work order from the maintenance order module to be displayed.

  10. Activate the 'Display hold MO' field if you want the hold manufacturing order to be displayed.

  11. Finish by pressing Enter.

Parameters to Set

Program ID/ Panel Field The field indicates…
PMS230/P Lock view

…whether the view can be changed on the B panel.

The valid alternatives are:

0 = View may be changed

1 = View may not be changed.
Create 1 page

…whether the sub-file should be created one page at a time or whether the whole sub-file should be created immediately. No totals will be calculated if the parameter is turned on.

The valid alternatives are:

0 = Whole sub-file is created immediately

1 = The sub-file is created one page at a time.

The parameter will only be observed if you use the standard sorting order, that is, start date, product number, order number and operation number.
Display work order

…whether the work order from the maintenance order module should be displayed.

The valid alternatives are:

0 = Maintenance order should not be displayed

1 = Maintenance order should be displayed.
Display hold manufacturing order

…whether hold manufacturing orders with status X5 are displayed.

0 = Do not display hold manufacturing order

1 = Display hold manufacturing order
Related topics