Print Manufacturing Order Documents

Outcome

• If you start 'Manufact Order. Print Separate Documents' (PMS250) from 'Work Center Schedule. Open' (PMS230) by selecting alternative 6-'Print document,' you will proceed from the work center. Documents related to the operations are predefined. Select 'New.'
• If you start 'Manufact Order. Open' (PMS100) by selecting alternative 6-'Print,' you will proceed from the MO number. All documents are selected. You may specify the desired number of copies you want to print of these documents:
  • Put-away card
  • Labor card
  • Routing card
  • Material requisition
  • Shop traveler card
  • Design document.

These are the uses for the documents:

• The put-away card shows where the end product will be stored.
• The labor card shows planned times and/or piece rate for the operation.
• The routing card shows in which order the operations will be performed, including work center, tools, setup time and run time for each operation.
• Material requisition is used to collect material from the store and for registering that the collected material has left the store.
• A shop traveler card identifies the material on a manufacturing order and contains information about which workshop the material should be transported to. The shop traveler card follows the physical order through the workshop.
• Design documents are used for configured products. In a design document you find information about the end product, for example, color, size and extra equipment.

The documents are marked as Printed on the manufacturing order.

Before you start

Manufacturing orders must exist, according to Creating Manufacturing Order.

Follow these steps

Select either to print documents for separate manufacturing orders or to print documents within a range of manufacturing orders.

• If you want to print a range of documents, follow steps 1-8.
• If you want to print separate documents, follow steps 9-16.

1. To print documents, start 'Manufact Order. Print Documents' (PMS240).

2. Specify the start date.

3. Specify the interval for these fields:

   • Facility
   • Product number
   • MO number
   • Reference order number
     • Reference order category

       Manufacturing order is order category 1.

     • Reference order number

       Refers to next higher level processes or order.

     • Reference order line

       The lines refer to a reference order number and show the line number on the order.

   • Project number
   • Responsible

4. Specify the status of the manufacturing order.

5. Select, if desired, to print all order-initiated manufacturing orders.

   To print an order-initiated manufacturing order, planning method 3 must be used.

6. Specify the order for the fields by selecting a number after each field. The lower the number, the higher the priority.

7. Select the 'Labor tickets' fields that you want to be on the labor ticket or tickets:

   • Tempo elements
   • Documents
   • Tools
   • Inspection.

8. Press Enter to finish.

9. To print separate documents, start 'Manufact Order. Print Separate Documents' (PMS250).

10. Specify the product number.

11. Specify the manufacturing order number.

12. Specify, when necessary, the operation number.

13. Select 'New.' You should now be on the E panel.

    The upper part of the E panel consists of fields that have been automatically filled in due to information you filled in on the B panel.

14. On the middle part of the panel, specify the number of copies you want to be printed of these documents:

    • Put-away card
    • Labor card
    • Routing card
    • Material requisition
    • Shop traveler card
    • Design document.
    Note: If the 'Documents printed' check box is selected, the documents have been printed before.

15. Select the 'Labor tickets' fields that you want to be on the labor ticket or tickets:

    • Tempo elements
    • Documents
    • Tools
    • Inspection.

16. Press Enter to finish.