Specify Whether Deviations in a Model Level are Additions or Reductions

This document explains how you define a difference in a model level. The difference can be either an addition or a reduction compared to the baseline of the model.

Use this instruction when both the model levels and the intallation positions for a model are defined.

Outcome

Each of the deviations from the base model in a model level is defined as either an addition or a reduction.

Information about additions and reductions is stored in the file (MCFMVL).

At the end of this process, you have instant information about the deveating positions.

Before you start

  • A model must be defined in 'Model/Site. Open' (MOS400).
  • A model level must be defined in 'Model/Site. Connect Model Level' (MOS420).
  • Installation positions must be defined for a model in 'Model/Site. Open' (MOS400).

Follow These Steps

  1. Start (MOS455/B).

  2. Select a predefined model and model level.

  3. Select the component. Select 'New record' to display the E-panel.

  4. Specify if the entry is an addition or a reduction to the baseline. Press Enter.

    The field should be left blank for baseline entries.

  5. Repeat steps 2 to 4 for all deviating positions.

Related topics