Connect Installable Components to Configuration Positions
This document explains how you connect the components that may be installed in the positions you have defined for a model.
Use this instruction when you have defined a new configuration or when you want to update an existing configuration with new components.
Outcome
The configuration has a list with all components that may be installed in the defined installation positions.
The list prevents you from installing any unapproved components in the configuration.
You can also use the list define the following:
- What meters to be used for the component installed in a load position
- The effectivity for the installed component
- Possible component combinations
The files with information about model level lists (MCFMVL) and configuration position variant (MCFLVA) are updated.
Before you start
- A model must be defined in 'Model/Site. Open' (MOS400).
- The model must have positions defined in 'Model/Site. Connect Position' (MOS440).
Follow These Steps
-
Start 'Position. Connect Components' (MOS450/B).
-
Select the model or site you wish to connect components to. Press Enter.
-
Select a predefined configuration position to add a component to and a predefined component. Select 'New Record'.
Panel (MOS450/E) is activated.
-
On the E-panel, select the appropriate status. Press Enter.
The valid alternatives are:
10=Prelininary
20=Definite
90=Blocked/expired
-
Repeat steps 3 and 4 until all positions in question have components connected.