Close Work Order
The purpose of the procedure is to close a work order.
Before You Start
Prerequisites Before you begin, the following prerequisites must be met:
- All operations and material lines must be reported for the work order (status 90). This applies if parameter 18 in 'Settings - Maintenance' (CRS788) is set to 2.
- The service(s) included in the work order must be approved (status 70).
Follow These Steps
-
Start 'Work Order. Close' (MOS050).
This program can be accessed directly or in one of the following ways: Start 'Work Order. Open' (MOS100), highlight the order to be closed and select option 'Close WO'; or start 'Work Schedule. Open Toolbox' (MOS195), highlight the last operation that belongs to the work order to be closed and select option 'Close WO'.
-
Enter the warehouse and location in which the object is to be placed.
-
If the 'Next item no.', 'Next S/N', 'Config position', Warehouse and Location fields are specified, clear them.
-
Confirm by pressing Enter. The work order is closed and the status of the work order is updated to 90 or 94.