Schedule Daily Processing panel

From this panel, you can schedule transfers of the AllData data set from the source system to M3 Graphical Lot Tracker. These data sets are included:

  • Master Data
  • Order Data
  • Transaction Data

The default value is ‘Not enabled’.

To ensure that the AllData set is up to date for the trace line, enable the job schedule immediately after the result of the initial load is verified. Use the Schedule Daily Processing panel.

  1. Select System Administration > Schedule Daily Processing.
  2. On the Schedule Daily Processing page, to enable the function, select the Enabled check box.
  3. In the Frequency field, set the schedule to run once a day, hourly, or every second, fourth, eighth, or twelfth hour.
    Note: The UTC time zone is used for the date and time in the Schedule Daily Processing panel.
  4. If the schedule must run longer than a day, then specify a start date and time for the last run.
  5. Click Save.