Configure the connection to the Lawson Security server

Note: If you are installing DSP for LBI or MSCM, you must make LSF selections here. LSF must be the primary authentication service in for LBI and MSCM.
  1. From the drop-down, select the system that will be your primary authenticating service.
    • For Lawson System Foundation as primary, select LSF

    • For Landmark as primary, select Landmark.

  2. Provide connection details:
    The network-accessible of the Lawson Security Server

    The fully-qualified domain name of the Lawson System Foundation or Landmark machine. This must be the machine where security server for the primary authenticating service you chose above resides.

    The standard port for the Security server

    This port was defined during the LSF or Landmark installation. You can find the value by checking the install.cfg file on your system:

    For LSF, use the LSPORT value in LAWDIR/system/install.cfg.

    For Landmark, use the LASE_PORT value in LASYSDIR/install.cfg.

    The secure port for the Security server

    This port was defined during the LSF or Landmark installation. You can find the value by checking the install.cfg file on your system:

    For LSF, use the LSSSLPORT value in LAWDIR/system/install.cfg.

    For Landmark, use the LASE_PORT_SSL value in LASYSDIR/install.cfg.

    Enter the password for the ssoconfig (LSF) or secadm (Landmark) utility

    If you chose LSF as your primary authenticating service, specify the password for the ssoconfig utility.

    If you selected Landmark as your primary authenticating service, specify the password for the secadm utility.

    Select Next.