Job handling procedure

With the job handling procedure, you can start, block, cancel, queue, and release jobs.

This procedure results in a job that runs according to the job calendar or interval that is defined in the job’s basic data. The job runs without user interaction. This helps you to use LN ’s resources more efficiently.

Prerequisites

You can only use the job handling procedure when the job data procedure is completed.

Steps in the job management procedures

Depending on the job’s status, these methods are available to start a job:

The job status is In Queue, the Job Scheduler BSE Service starts the job.
The job’s status is Free, you can start the job by running the session.

To run the job with Activate Job (ttaad5203m000)

Because your running bshell starts the job, you cannot close the bshell until the job is finished. If the job is started before the time and date of execution, the job’s status changes to Waiting. When the job is carried out, the job’s status changes to Running.

If you must start a job that belongs to more than one company, switch to the required company. Use the Change Company command, before you start the job.