To set up inspection methods for operations

If the Routing (TI) check box in the Quality Management Parameters (qmptc0100m000) session is selected, you can use Quality to check the products of operations.

You can start the Order Specific Test Procedures (qmptc0149m000) session from the Production Planning (tisfc0110m000) session.

You can define the quality requirements for each operation.

The following fields determine which of the methods mentioned in Manufacturing operations section can be used:

  • Blocking Method for Inspections
  • QM Only Recommends

These fields are available in the Order Inspections (qmptc1120m000) session.

  • LN uses method A, if the following conditions are met:
    • Blocking Method for Inspections = Continue
    • The QM Only Recommends check box is selected
  • LN uses method B, if the following conditions are met:
    • Blocking Method for Inspections = Block on Completed Operation
    • The QM Only Recommends check box is selected
  • LN uses method C, if the following conditions are met:
    • Blocking Method for Inspections = Block on Operation
    • The QM Only Recommends check box is selected
  • LN uses method D, if the following conditions are met:
    • Blocking Method for Inspections = Block on Operation
    • The QM Only Recommends check box is cleared

LN determines the value of these fields on the basis of the data you enter in the Order Specific Test Procedures (qmptc0149m000) session.