View Assembly BOM and Operations

Restrictions

If the External Assembly Parts and Operations check box in the Assembly Planning Parameters (tiapl0500m000) session is selected, the flattened parts and operations are delivered from an external source. As a result, you cannot change the data in the current session, except when you work in Test Mode. If that check box is cleared, the assembly parts and operations are flattened during the calculation of the assembly part requirements.

You can modify data in this session only if your current company is defined as master company.

Procedure

After you change the data in this session, you must run the following sessions:

  • Calculate Assembly Part Requirements (tiapl2221m000) or Calculate Assembly Part Requirements (Multiple Bshells) (tiapl2222m000)
  • Refresh and Freeze Assembly Orders (tiapl3203m000) or Refresh and Freeze Assembly Orders (Multiple Bshells) (tiapl3204m000)

Operations independent from assembly parts

To define operations which are not linked to a specific assembly part, leave the Assembly Part field empty. LN takes these operations into account when it creates line-station variants.

Related topics