Inspection Order Samples (qmptc2110m000)
Use this session to maintain samples. After a storage inspection order has been created, but before the inspection can be carried out, you must draw a sample which is representative of the entire inventory of an item.
You can draw more than one sample, but the total quantity of these samples cannot exceed the sample size which was specified for that inspection order in the Test Groups (qmptc0136m000) session. To complete an inspection order the total sample quantity must equal the sample size.
After you have been set up the samples, use the following sessions to finalize the inspection order:
- Inspection Order Test Data (qmptc1115m000) or Sample Test Data by Serial Number (qmptc1116m000)
- Complete/Process Order Inspections (qmptc1202m000)
- Process Inspection Orders (qmptc1204m000)
Field Information
- Inspection Order
- Maximum Size
-
The maximum size of the sample quantity depends on the test type.
100 % or Single Sampling:
- Maximum Size = " Sample Size "
Continuous Sampling:
- Maximum Size = ( Order Quantity/ Frequency) x Sample Size
The sample of continuous sampling is equal to the sample size.
- Total Quantity
-
The total quantity of all samples. In the end, the quantity must equal the sample size.
- Item
- Origin Order Sequence
- Sample
- Warehouse
- Location
- Lot
- Date
- Test Quantity
-
Note: For each test quantity, the result of the test can be entered in the Inspection Order Test Data (qmptc1115m000) session or in the Sample Test Data by Serial Number (qmptc1116m000) session.
- Sample Quantity
- Sample Time
-
The date on which the samples are taken.
- Test Data
-
If this check box is selected, test data is available.