Definition of 'Standard' (ttadv0104m000)
Use this session to maintain the tools definition standards. These standards are filled during installation and can only be modified by the software vendor.
The session is password-protected. You must specify the password on the Password tab.
note
You can change the required password in the Change Password for Definition of 'Standard' (ttadv0105m000) session.
On the Definition tab, you can specify the definition of the Standard for every position in these codes:
You can specify several characters for every position. If a package VRC has one of the defined characters on the specified position, the package VRC is standard.
If you leave a particular position blank for a definition, each character in this position conforms to the definition Standard.
Example
This table shows an example:
Package | Position 1: | tux |
Position 2: | ||
Version | Position 1: | |
Position 2: | ||
Position 3: | ||
Position 4: | CLDJB | |
Release | Position 1: | |
Position 2: | ||
Customization | Position 1: | |
Position 2: | ||
Position 3: | ||
Position 4: |
All the package VRCs with the letter t, u, or x on the first position of package and the letter C, L, D, J, or B on the fourth position of the version are standard package VRCs.
This table shows examples of Standard Package VRCs:
ch | 1.1 | a | |
ti | 2.2 | a | |
ti | 2.2D | a | dach |
ua | 2.2J | a | dach |
This table shows examples of Non-Standard Package VRCs:
ch | 1.1L | a | citr |
ti | 2.2O | a | cust |