To set up inspection methods for operations

If the Routing (TI) check box in the Quality Management Parameters (qmptc0100m000) session is selected, you can use Quality to check the products of operations.

You can start the Order Specific Test Procedures (qmptc0149m000) session from the Production Planning (tisfc0110m000) session.

You can define the quality requirements for each operation.

The following fields determine which of the methods mentioned in Manufacturing operations section can be used:

  • Blocking Method for Inspections
  • QM OnlyRecommends

These fields are available in the Order Inspections (qmptc1120m000) session.

  • Infor LN uses method A, if the following conditions are met:
    • Blocking Method for Inspections = Continue
    • The QM OnlyRecommends check box is selected
  • Infor LN uses method B, if the following conditions are met:
    • Blocking Method for Inspections = Block on Completed Operation
    • The QM OnlyRecommends check box is selected
  • Infor LN uses method C, if the following conditions are met:
    • Blocking Method for Inspections = Block on Operation
    • The QM OnlyRecommends check box is selected
  • Infor LN uses method D, if the following conditions are met:
    • Blocking Method for Inspections = Block on Operation
    • The QM OnlyRecommends check box is cleared

Infor LN determines the value of these fields on the basis of the data you enter in the Order Specific Test Procedures (qmptc0149m000) session.

Related topics