| To set up inspection methods for operationsIf the Routing (TI) check
box in the Quality Management Parameters (qmptc0100m000) session is selected, you can use Quality to check
the products of operations. You can start the Order Specific Test Procedures (qmptc0149m000) session from the Production Planning (tisfc0110m000) session. You can define the
quality requirements for each operation. The following fields determine which of the methods
mentioned in Manufacturing operations section can be used: - Blocking Method for Inspections
- QM OnlyRecommends
These fields are available in the Order Inspections (qmptc1120m000) session. - Infor LN uses method A, if the following conditions are met:
- Blocking Method for Inspections = Continue
- The QM OnlyRecommends check box is selected
- Infor LN uses method B, if the following conditions are met:
- Blocking Method for Inspections = Block on Completed Operation
- The QM OnlyRecommends check box is selected
- Infor LN uses method C, if the following conditions are met:
- Blocking Method for Inspections = Block on Operation
- The QM OnlyRecommends check box is selected
- Infor LN uses method D, if the following conditions are met:
- Blocking Method for Inspections = Block on Operation
- The QM OnlyRecommends check box is cleared
Infor LN determines the value of these fields on the basis of the data you
enter in the following sessions: - Quality Combinations (qmptc0111m000)
- Order Specific Test Procedures (qmptc0149m000)
| |