| TroubleshootingCross-docking I cannot enable cross-docking in the Warehouse - Item
(whwmd2510m000) session. Make sure to select the Dynamic Cross-docking check boxes in the following
sessions: - Inventory Handling Parameters (whinh0100m000)
- Warehouses (whwmd2500m000)
- Items - Warehousing (whwmd4500m000)
I created a cross-dock order and a cross-dock
order line, but received goods are still not cross-docked. Goods are in bounded
instead. The cross-dock order line must be approved before inbound advice.
This can be done in several ways: - Approve the order line manually in the Cross-dock Order Lines (whinh6110m000) session.
- Approve the order line using the Approve Cross-dock Order Lines (whinh6210m100) session.
- Select the Automatically Approve Cross-dock Order Lines check
box in the Warehouse - Item (whwmd2510m000) session.
The following also applies: - Specific outbound lot must match inbound lot, when using
lots in inventory.
- Outbound and inbound effectivity unit must match.
- Specific outbound serial must match inbound serial, when
using serials in inventory.
- Inbound package definition must
match outbound package definition, if package definition has been defined on
the outbound line.
- Is the Unit Binding check box selected in the Outbound Order Lines (whinh2120m000) session?
I expected a
cross-dock order to be created when releasing my order to warehousing, but this
does not happen. In the Warehouse - Item (whwmd2510m000) session, check the following settings and
fields: - Dynamic Cross-docking
Generate Cross-dock Order when Releasing Order to Warehousing If set to Never,
no cross-dock order will be created anyhow. If set to Time Phased Shortage, there might be enough time-phased
inventory, so no cross-dock order will be created. Minimum Cross-dock Quantity/ Maximum Cross-dock Quantity If the expected cross-dock quantity lies outside these
boundaries, no cross-dock order will be created. Note: this also applies if
the maximum cross-dock quantity is zero!
If you are trying to cross-dock lots not in inventory or
serials not in inventory, in the Default Order Types by Origin (whinh0120m000) session, check the following
setting: | |