Shop Floor Control

Changes have been made:

• It is no longer possible to manually insert lot codes in to the production order distribution of the Production Warehouse Orders (timfc0101m000) session.
• The lot code on a distribution is derived from the lot code in the order header.
• Lot codes fields in the sessions Report Orders Completed (tisfc0520m000) and Report Operations Completed (tisfc0130m000) are accessible again for Project Peg - Production Orders (tisfc0105m300).
• The lot code generation logic for project pegged order was replaced with the original logic for Report Orders Completed (tisfc0520m000), Report Operations Completed (tisfc0130m000), Report Orders Completed Globally (tisfc0206m000) and Order Distribution (tisfc0105m100).

• Infor LN 10.2.0

  In Infor LN 10.2.0 when distributing not the exact quantity but more or less than the full quantity of the material, the quantity is distributed over the distribution lines with project pegs in three steps:

  • When 'less than ordered' is handled, soft pegging data from Enterprise Planning is used to determine which supplies requirement date and requirement quantity is needed for each distribution line. Due to lot size rules, requirement quantity can be less than the ordered quantity. The distribution lines are handled in sequence or by requirement date.
  • If no soft pegging data is available or the complete required quantities from soft pegging data are fulfilled, the distribution lines are handled in descending sequence of the order quantity until the order quantity is fulfilled.
  • If the complete ordered quantities are fully fulfilled, the remaining quantity to fulfill is prorated over the distribution lines.
• Infor LN 10.2.1

  In Infor LN 10.2.1 pegged demand lines are given priorities above unpegged demand lines during the first and second step.

  In case of step one when the requirement date is the same on a pegged and unpegged order and at step two when ordered quantities are the same.