Configuring Enterprise Connector

To configure the Enterprise Connector service:

  1. Go to the Windows system where the Enterprise Connector service is installed.
  2. Open the Grid Management UI.
    1. Run the file <Installation folder>\bin\AdminUI.cmd
    2. Accept the certificate warning.
    3. You can run AdminUI.cmd with another Windows user than the one used to install ION Enterprise Connector. In that case you must add your user to the local Windows Group IONEnterpriseConnector_full or <installfolder>_full
      To add the user on Windows, start lusrmgr.msc
  3. In the Grid Management UI, click the Applications tab and complete one of these steps:
    • If the applications are displayed in list view, then click the Overview tab at the bottom of the page. Then, in the Details section, click Management Pages.
    • If the applications are displayed in cards view, then click Management Pages.
  4. Specify the location credentials you retrieved from the ION CE Location screen by either importing the credentials csv file or pasting the ID and Security Key; click Load.
    The location information for this location is retrieved from ION CE and displayed.
  5. If your on-premises applications exchange messages using another tenant than the ION CE tenant, define the on-premises tenant in the Tenant Mapping field. The Enterprise Connector converts the tenant of the messages from cloud to on-premises tenant and vice versa.
    Note: You can only change the tenant mappings if there are no active connection points. To change the mapping when there are active connection points, you must deactivate the related document flows to deactivate these connection points. Then, change the tenant mapping and activate the document flows again.
  6. Click Save.
    The Enterprise Connector service is updated to use the configuration.