General generic UOM
This section describes data substitution records that provide cross-references for all trading partner transactions.
L1_O_UOM
Cross-reference for outbound unit of measure for all trading partner IDs.
- Cross-reference
- Optional
- Default: If substitution is not found, the purchase order UOM is mapped to the 850.
- Related: LOOKUP_O_UOM
| Field | Value | Examples | Comment |
|---|---|---|---|
| Your Name | L1_O_UOM | ||
| Your Value | <your UOM> | ||
| Partner Value | <outbound UOM > |
Use this if you use non-standard X12 codes for UOMs, such as CASE, BOX, and EACH. X12 standards use specific UOM codes and are min/max size of two characters. For example, CA, BX, EA.
If you use standard codes, you can disable the lookup using the LOOKUP_O_UOM to disable the outbound lookup.
L1_I_UOM
Cross-reference for inbound unit of measure for all trading partner IDs.
- Cross-reference
- Optional
- Default behavior: If a record does not exist, the UOM from inbound X12 data is mapped.
- Related: LOOKUP_I_UOM
| Field | Value | Comments/examples |
|---|---|---|
| List Name | L1_I_UOM | |
| Your Value | <your UOM> | |
| Partner Value | <inbound UOM> |
Use this if you use non-standard X12 codes for you UOMs, such as CASE, BOX, and EACH. X12 standards use specific UOM codes and are min/max size of two characters. For example, CA, BX, EA.
If you use standard codes, you can disable the lookup using the LOOKUP_I_UOM to disable the lookup.
LOOKUP_O_UOM
Enables and disables performing an outbound unit of measure data cross-reference substitutions.
- Configuration
- Optional
- Default behavior: If record does not exist or record exists and Partner value is not N, then UOM lookup is performed.
- Related: L1_O_USE_TP_UOM, LOOKUP_I_UOM
| Field | Value | Example | Comment |
|---|---|---|---|
| List Name | LOOKUP_O_UOM | ||
| Your Value | <tpid> or * | ||
| Partner Value | N | Use Y to enable for a specific trading partner |
Use to disable outbound UOM cross-reference lookups. The default is to perform UOM cross-reference lookups. If you and your trading partner use standard X12 UOM value in your transactions, UOM substitutions are not required, nor are lookups. If L1_O_USE_TP_UOM is enabled, that lookup is performed.
LOOKUP_I_UOM
Enable and disable performing an inbound unit of measure data cross-reference substitutions.
- Configuration
- Optional
- Default behavior: If record does not exist or record exists and Your Value is not N. L1_I_UOM is performed.
- Related: LOOKUP_O_UOM, L1_I_UOM, L1_I_USE_TP_UOM
| Field | Value | Example | Comment |
|---|---|---|---|
| List Name | LOOKUP_I_UOM | ||
| Your Name | N | Disables lookup. Use Y to enable for specific trading partner | |
| Partner Name | <tpid> or * |
Use to disable inbound UOM cross-reference lookups. The default is to perform UOM cross-reference lookups. If you and your trading partner use standard X12 UOM value in your transactions, you do not need UOM substitutions and do not need to perform the lookups.