Adding measurement values

After providing measurement details and adding points of measure, you must specify the values for tolerance and initial measurement to determine measurements for each size.

  1. In the Summary section of the Master Page, specify this information for every point of measure:
    Tol +
    Set the permissible value that a size can exceed the indicated measurement.
    Tol -
    Set the permissible value that a size can go below the indicated measurement.
    Initial Measurement

    Specify the initial measurement for the style.

    The value you provide will be applied to the sample size that you selected.

    Note: To indicate a negative value, specify a minus sign before the value.
  2. In the Graded Increment section of the Master Page, provide measurement values or gradings for other sizes other than the sample size.

    A graded increment pertains to a fixed amount that differentiates the measurements between sizes.

    The number of sizes depends on the size range that you selected.

    Note: If you add POMs from a grade rule that has gradings, the Graded Increment section will display values from that grade rule.

    If you update the measurement values or gradings of multidimensional sizes, all other sizes with the same base or reference value will also be updated.

  3. Click the Graded Measurement section to view the measurements for each size.
    Note: If you delete a size in the Size tab of a style record, the size will be removed in the style, Graded Increment tab, and Graded Measurements tab.

    If you changed the status of a size to inactive, the size is grayed out in the Graded Increment and Graded Measurements tab.

  4. Click Save or Save and Close.