Register Work Instruction

The purpose of the procedure is to register a work instruction.

Before you start

Before you begin, the following prerequisites must be met:

Follow these steps

Follow the steps below to add a operation element to a work center.

  1. Start 'Work Center. Open' (PDS010).

  2. Mark the work center to which the operation element is to be connected. Select Work Instruc (option 14).

    Result: 'Operation Element. Open' (PDS025) is displayed.

  3. To register a work element, go to step 4.To register a work element - descriptive, go to step 5.

    To register a tool, document or inspection, go to step 6.

  4. Enter the task element no., operation element type and operation element ID. In panel E, complete the data.

    Note: The set up and run times will be added to the total times for the work center.

    Go to step 7.

  5. Enter the task element no., operation element type and operation element ID. In panel E, complete the data.

    Note: The set up and run times will only be used as information, they will not be added to the work center times.

    Go to step 7.

  6. Enter the task element no., operation element type and operation element ID (tool, document or inspection ID). In panel E, complete the data.

    Go to step 7.

  7. The work instruction has now been added.

    To add additional work instructions, return to step 3.

Related topics