Setting filters

Set filters on the Incidents page to determine the data that must be displayed.

  1. Select Monitor > Incidents on the navigation bar. The Incidents page is displayed.
  2. Expand the Filters section.
  3. Specify this information:
    Filter Name
    The name of the filter.
    Insight
    The name of the Insight for which incidents are displayed.
    Risk Assessment
    The risk assessment for which incidents are displayed.
    Category
    The category of the questionnaire for which incidents are displayed.

    This field does not display when incidents are created using the default compliance checklist. The default compliance checklist is generated based on the risk category identified for the risk assessment response.

    Severity
    The severity of incidents that are displayed.
    Status
    The status of incidents that are displayed.
  4. Select one of these options:
    • Apply: To display incidents based on the filters selected.
    • Save: To specify a name for the filter. You can reuse the selected filter parameters in future. The saved filters are displayed on the Saved Filters tab.
    • Reset: To reset all the filters on the Saved Filters tab.