Modeling a percent fit for a candidate

If you are considering a candidate for a position, you can compare the candidate's qualifications with the position's qualifications using the Model Percent Fit action.

Before you start, the Model Percent Fit settings must be set in Administrator Space > Setup > Organizations. Configuring percent fit calculation and display rules

To perform gap analysis

  1. Access Recruiter > Candidate Pool.
  2. Locate the candidate that you want to analyze and open the candidate's record.
  3. On the Candidate Details page, access the Fit Analysis tab.
  4. Click the Model Percent Fit button.
  5. On the Model Percent Fit Form, specify the following field values.
    Compare Position

    Required. Select the position that you want to compare the candidate to.

    Essential Only

    If you want the comparison to include only essential qualification, select this check box. If you do not select this check box, the comparison will include all the qualifications defined for the position, whether essential or not.

    Note: 

    The Essential Only setting on the organization's Percent Fit Organization tab defaults on this form. You can change it.

  6. Click OK.

    The system refreshes the page.

  7. The fit percent displays at the top of the page, followed by a spider graph comparing the position's skills and competencies' requirements with the candidate's qualification. Click Graph to view the same information as a bar or pie graph. Scroll down to view a list of the position's essential or essential and non-essential qualifications included in the percent fit calculation. For each included qualification, the system displays a red alert with the comment "No Match" or a green alert with the comment "Match". The percent fit is derived by dividing the number of qualifications that match by the total number of qualifications included in the calculations.
    Note: 

    The settings on the HR organization's Percent Fit Organization tab determine the qualification types that are included in the calculations.